Honda Civic DPF remove and problem...

by **franz727272** » Thu Nov 22, 2012 1:48 am

I can't understand this things, usually with DPF on my car start regeneration after 6,9 gr. of PM.
Since I disabled the DPF the engine does not trigger more regeneration.
There is never white smoke.
But I see that the PM HDS continues to climb the same.
This is impossible because I put a pipe in place of the dpf and I disconnected the pressure sensors and differential EGT2.
How does these calculations particulate? :evil: :problem:
http://imageshack.us/f/705/hdshondadpfoff.jpg/

I tryed Ecusafe 2.0, Shiftec v.2, Volta and manual service...no solution yet...and cruise control not working every 1.000 km I have to reset the PM with HDS and it goes back to work :x

by **bubba80** » Sun Dec 02, 2012 10:59 pm

I know that only manual modifies works...

by **franz727272** » Mon Dec 03, 2012 1:14 pm

bubba80 wrote:I know that only manual modifies works...

Who made this manual modifies in Italy?
I dont know who made this manual mod on honda civic with working cruise that have garage.
I'd like to go there and try.

I am looking for a witness who has removed the dpf of honda civic and have working cruise .
There are many forums honda civic discussing this problem but there is never a witness to some customers who removed the dpf and the cruise working, very strange :problem:

All over the web there is no evidence of this.

Many ecutuners say they know how to do, but still no one has proposed to help and find solution.
I'm not a tuner and I dont like joke with my ecu,
I dont wont paying before and after testing. I've already made this error :( After 1000 km the cruise disconnecting again. :x
They sell first mod sw. with DPF OFF and then if sw. does not work leave you alone with the problem saying that it is disabled right
and problem is on your car...

After many test Is strange that with dpf off in HDS I can see value of PM (calcolate particulate value) 59.7 gr.
and other value working ...may be the problem is that the sensor continue to estimate and I have not limp mod because switch off
only limp mode and DTC but not the sensor.

by **bubba80** » Mon Dec 03, 2012 3:14 pm

I don't know who did it in Italy, but i read on other forums someone says can...

would be sufficient to have the damos to study it and find the solution ...

by **franz727272** » Mon Dec 03, 2012 3:45 pm

bubba80 wrote:I don't know who did it in Italy, but i read on other forums someone says can...

would be sufficient to have the damos to study it and find the solution ...

Damos yessss. I never find it :roll:

Which forum did you see that there is a DPF off with cruise solution for Honda civic?

by **bubba80** » Tue Dec 04, 2012 2:14 am

I don't know if i can link other similar forums...

by **franz727272** » Tue Dec 04, 2012 10:25 am

bubba80 wrote:I don't know if i can link other similar forums...

You can send me PM :mrgreen: :thumbup:

by **Relic** » Tue Dec 04, 2012 4:57 pm

Fuel consumption since last regen success.
Calculated PM value

And there in lies the clue.
Semewhere is totting up total fuel use since regen = PM vale.
Somewhere there is a limiter for MAX PM value.

1000km should have nothing to do with cruise control.
I would think someone has screwed with a bad area of code.