I flash original kess v2 copy(only maps) MPPS V18 boot mode(bench) original ECU, flash is now same HEX than backup successful (there is not eeprom at all, I wait new empty chips and reader/writer xprog 5.55) so car wont start..
Many times change volts 12.0-12.7, many times graund flash memory pin and power up ecu..and its finaly works.. take few hours..
Other ECU (where original eeprom is now solder) works same than now this, so i think i just need new eeprom. Original is lost when flash kess v2, i think so its lost for ever..
I try solder it back original ecu tomorrow, but i dont think it helps..
I found immo off 1 kt file, if i try this file write new eeprom and solder it original ecu, maybe works?
Again, Few weeks wait for tools....
Still looking confirm immo off eeprom file... its 1 kt file?










