nipper76 wrote:i dont have access to pp2000 so might have to get on Ebay.

Yes pp2000 is needed. eBay is not the cheapest source, other sites are cheaper.

nipper76 wrote:oh... so clearing the codes with say, a Snap on universal scanner wouldnt solve the issue..?

i dont have access to pp2000 so might have to get on Ebay.

i opened up the binary in winOLS... makes no sense to me, how do you understand what part you would change and the value you change it to..?

Just erasing the codes will NOT get you out of limp mode. You must set the BSI to car witnh NO FAP filter to run it problem free. The only tool that can do this is PP2000.

Years of experience and a lot of testing helps a lot when you look at the binary. ;)

Ok... so ive finally got my PP2000 up and running.
plugged it in a cleared all the codes, except - Fuel Additive Control Unit. Perm Fault. Piesel Aditive Pump.

cant see how to switch the fap off within any of the settings...
did see a bit where it was asking how much of the additive you wanted it to inject... was set at 9, so i set it to 0.

car is currently out of limp mode now thank god.

so i thought id now attempt to connect the galletto up to take a new copy of the ECU details now the faults have almost all been cleared. the run it through ECUsafe and upload it back....

well.... my galletto is now not reading the ECU..???

it goes through the process of reading it, but returns with error.

can anyone help at all..?

the error is : turn off dash wait 10s then turn on

found how to deactivate FAP with pp2000...
and a few other cool lil features :)

just stuck with the galletto cable :/

the error is : turn off dash wait 10s then turn on

Just wait 10 second. Do nothing. After 10 sec click OK. That all that you have to do.

ill get a screen shot to try to explaine...

heres the screen shot..

Your galletto does not work. That happens when it dies...

well that lasted long... on scan, ut back in the box and it dies... hmmm
ive emailed for a replacement... fingers crossed.