Maps needed for tuning EDC15C2

by **manekin13** » Sat Sep 27, 2014 9:41 pm

Yes, I think You are right

by **ALVK_DE** » Mon Oct 20, 2014 8:21 am

hi friends.
tell me, I have correctly identified the card Rail Press Limiter.
my ori file P807 (368404) + .kp format WinOLS.
featured a card RPL 6x14
I checked their assumptions on the file of this topic, which kindly provided ecuedit and another friend from P807 2.0L.
attached a few pictures for comparison.
size cards RPL in my case it turns 6x14 but not 8x16 otherwise not true factors and offsets.
it turns out that the limit of pressure in my firmware is installed in the fuel and 60 mm3 1300 Bar From 600 rev / min.
please verify my assumptions.

by **leonevich** » Mon Oct 27, 2014 9:08 am

The size is right, the axis is not correct. Look directly in front of map your axiss

by **ALVK_DE** » Mon Oct 27, 2014 6:03 pm

leonevich wrote:The size is right, the axis is not correct. Look directly in front of map your axiss

I can not understand what the axis wrong?

by **leonevich** » Mon Oct 27, 2014 6:57 pm

Look at the hexdump around map, axes are of adequate size 14 and 6. Those that you have chosen, not to this map and other size.

by **ALVK_DE** » Mon Oct 27, 2014 7:18 pm

leonevich wrote:Look at the hexdump around map, axes are of adequate size 14 and 6. Those that you have chosen, not to this map and other size.

maybe so?

by **ALVK_DE** » Mon Oct 27, 2014 8:16 pm

ALVK_DE wrote:
leonevich wrote:Look at the hexdump around map, axes are of adequate size 14 and 6. Those that you have chosen, not to this map and other size.

maybe so?

Rail Pressure Limiter for the 607 axis of the correctly, for the 807 I can not find such. 607 8x16 card, 807 card to 6x14.