hello there...

can anybody check following two files and help me tell, which of those tunes are better for my car?

On first one, car drives well only at high revs, like 3500 and more, but shakes really really badly at low revs around 1800 (really scary sounds when accelerating quickly from this point, like something is bad here).

On another one, I tryed to push power from higher revs...

Also, I cannot figure out, how to turn off EGR in this car... tryed several times but still with no success... tryed through ECM titanium and WinOls, but still, car shows EGR control light... :(

Please post original (stock) file

here it is... original from car

quick review on second file

Precentage tuning everywhere!!

DW - precentage tuning 17,5% increase everywhere...
torque limiter increase by 50,3 % everywhere from 1000rpm....this is clutch and turbo killer ,
also it allows 375 nm at 1900 RPM which is actually in stage 2 and this much fuel this low rpm is certanly turbo & clutch killer
maf smoke limiter - THANK GOD due to poor knowledge the "tuner" didnt know about MAF limiter so the car is limited to 56mg fuel @ 2500 (around 304 nm) but also increased in precentage 9,2%
Map smoke limiter - car is limited to 50mg fuel until 3000rpm also increased by precentage but he forgot to change last ( most important) collumn
Lambda Maps - funniest thing of all he INCREASED lambda maps which is actually more limiting fuel (Worse preformance) haha so this is hilarious (altho it's not used by ecu so no point in changing)
NM to IQ - decalibrated... by precentage (5%)
Duration maps - decalibrated... by precentage (4,5%)
Boost map - increased by 8% precentage even at part load which should result in less preformance in part load
EGR wrong off - still active
N75 stock - you will most likel overboost
SVBL missed

this map is completely precentage tuning and the guy has no idea what he is doing

everythng i said goes for first file, it is almost indentical file made by same guy, both files are crap

oh fuck... and I payed for that... which software did you used for checking this?

I have quite experience with EDC15 units, tuned through VagEDCSuite, I cannot figure out how to recognise maps in winols, I found also some damos files, which I actually didnt made working in my winols... :(

Winols is the best tool available imo

thanks for advice... will try to learn with it...

may I ask you, for the last time, could you please "repair" that mod by your best knowledge? I would compare it with this one and original file, to just start learning those differences please?

if you want to learn you can check which maps your "tuner" edited to get basic idea how maps look in winols (2d,3d)

thats the first step - indentifying maps