FAP removal and temp sensor

by **silhouette** » Thu Mar 19, 2015 11:02 pm

is it possible to get new "antipollution fault" after dpf removal and dpf off with ecusafe long time ago?

by **ionutsnake** » Mon Jun 01, 2015 8:22 pm

I try also with ecusafe but dont work...

by **CountryGent** » Wed Jun 03, 2015 12:47 pm

My Peugeot 406 2.2 HDI has the same ECU it seems.
Ive read this post with great interest as i feel I'm getting closer to my goal.
I would really like to understand the methodology to achieve this.
Ive got the ECU file open in ECM Titanium but am not sure even if this is the correct tool. Can anyone advise please. I too used ECU safe first of all, but the car still goes into limp mode a few times a day, so it clearly does not work properly.

Let me know if anyone fancies explaining a bit about this to me.

Thanks
CG

by **wld** » Wed Jun 03, 2015 10:06 pm

Volta removes FAP better than ecusafe on this ECU. Afterwards you have to checksum the file and remove FAP also from BSI with Lexia/PP2000

by **weemh003** » Sat Jun 06, 2015 2:40 pm

Your car can still produce anti polution faults with fap and egr correctly removed in your ecu.
It can be that the turbo pressure is not correct or their is a faulty injector they all can cause the antiploution fault.
I use Peugeot planet and Dexhia to diagnose the cars fault.

by **stanleybg** » Sat Jun 06, 2015 7:47 pm

Ok do we need to furn off fap injection map off ( write zeroes) to corectly remove fap ? I think there are two switches to be turned off for the two temperature sensors in fap ? Am i wrong ? I think the right way is to turn off one switch in hardware switches map.But dont know how to locate it for different cars.

by **stanleybg** » Sat Jun 06, 2015 8:08 pm

I think even when you disable the two values for FAP temperature sensors you are don because they will show alway 751celsius temp and never have any problems with FAP.The other way is to modify hardware switches.Everythink is there like FAP , climate control , ESP options.But i don't know what and how to modify there.

by **stanislav georgiev** » Thu Jun 11, 2015 9:45 am

svkonstantin wrote:I tested it and it works if you need to remove the error will show you how

Colleague, your decision was made by Volta

by **stanleybg** » Thu Nov 05, 2015 9:52 pm

In hardware swithces is two 00032 and one 00042 that should be set to 0000.But i don't know whar are these for actualy.Someone to guide a little. :)

by **mistermekkmester** » Fri Jan 01, 2016 7:03 pm

Hello, how do you remove the Audi A6 3.0 TDI DPF? only the ecu must be turned off or taking out alive before the DPF filter detectors, after this? thx