Hi friends

i need clone edc16c8 from iveco, i use ktag
i buy edc16c8 second hand

i read fine MPC + flash + eeprom from both ECU ( original from iveco and second hand with same 0281xxx ) and save it

but when i want write original files ( MPC + Flash + eeprom ) from original ecu iveco to ECU second hand , KTAG write fine flash and eeprom but made error during writing MPC

i test write MPC backup file from second hand to this ecu second hand ( so original files from this ecu ) but no way ; KTAG always send " error during deleted / writing MPC ) and if i read this MPC (second hand ) i see KTAG modify this MPC file

anybody have solution for this ? for write my MPC correctly

So you did:
1. Read old ecu backup,
2. Read new ecu backup,
3. Write old backup to new ecu (but didnt work). Why you would write seperatly?! write full backup file.
If dont work test to write 1. mpc, 2. epr, 3.flash.
If also dont work ecu bricked in anyway.

Solved using old Bdn100
After this I test read new ecu using ktag
To compare files with ori reading with ktag
100 % ok

But car start very fine with ecu ori but not start with new ecu cloned

So is compatibility ? Edc16c8 have different version hardware/software ?

Thanks for your help ;)

Post picutre of label or id of both.
Did you think about injector coding... some ecus didnt remembert them -.- and need later coding (dont know if ktag also got this problem with).

Ktag software say " ecu can clone " so ...

with ktag you save all ecu inclued injector code

i will post both sw number