Hello everyone! Trying to find maps on this car usig winols. As i understood 3000 is using hitachi cpu.. what size of maps is on this kind of cpu? Or may be somebody can share the adress and size of such a maps:
1.rpm limit
2. engine load vs rpm (or torque limitation)
3. Fuel maps
4. Ignition maps
5. Second lambda bit.
There is a wish to install a couple of Catcams shafts.
Thanks, WBR Maxi. Ukraine.

seems your file is corrupted or missing engine data area

What tool did u read File With It May have been tuned already and a no read tag put in file Some tools respect No Read and encypt file 512kb is a full read

Yes, the previeous owner of my car said me that car was chiped already. I have downoad this file from the ecu with mpps v.12 in full read mode. and he has two files with calibration about 16kb each. One of the is original and the second one is tuned. But i downloaded the full dump from the ecu to have a chance with map findig. I tryed , but couldnt found them. What I need to do ? Maybe i can post here the ecu ident and try to find the original file... than maybe you help me?

Will try to read the car with Galletto 1260 only calibration area... It should be about 64k if i'm not mistake.

negative23 wrote:Will try to read the car with Galletto 1260 only calibration area... It should be about 64k if i'm not mistake.

64 is data area depend on tool I think galletto will do samr as mpps and read full 512

If he has the ori file that will not or should not be encrypted
So u should be able to see that file ok

I finally get the normal dump from my car ...
So the question is on topic..
If there some maps conected with camshaft timing it would be great to know where is the addres and whath is the axis ..
So here is the files... fullflash and data area..

I hope some GURU will help me =)))