Rate this tune please: Laguna III 2.0dci 150Hp ->180Hp

by **capske** » Tue Mar 18, 2014 3:57 pm

Hi,

Could someone please rate this tune.
Was bought from online tuning company.
Read & Written true OBD with galletto.
It's mainly to know if I can keep working with this company, because transaction & support was really ok.
Let me know if you need original file.

Thanks.

by **M780** » Fri Apr 18, 2014 4:17 am

Do you have ori?

by **zotto** » Tue Apr 29, 2014 6:50 pm

this file is good, nice job

by **capske** » Tue Apr 29, 2014 6:59 pm

Awesome, thank you very much zotto

by **FCMotorsport** » Wed May 28, 2014 8:40 pm

nice 1

by **parik** » Fri May 30, 2014 12:34 am

if you use clone galletto, have you problem with coding injections? thx

by **capske** » Fri May 30, 2014 9:23 pm

After the chiptuning i started the car without problems. But i did get an injector coding error.
I have the renault can clip software. Original renault software. This software told me that i had an injector coding error, but the codes were still written in the car and i had only to erase the dtc.
Iff you don't have software to erase the error codes; after the tuning, press the both buttons with which you can go check milage etc. At the same time for about 30 seconds. This will erase the error on the display that tells you that the car needs maintenance.
Don't forget after the tuning, at the cars initial start up to switch the button for cruise control a couple of times over (at least 3 times), because else the cruise control won't work. You'll ten have to go to renault dealer or someone who has the can clip to reactivate it.

I hope you can apply this and that your tuning goes well.

by **ernst** » Sun Jun 22, 2014 8:53 pm

This tune is bad.
You changed of regeneration SOI, maximum allowable Boost pressure regeneration mode, turbo for limp mode, maximum desired boost pressure depending on pressure pre particle filter, torque limiter for limp mode.
You don't changed partial of SOI (with pilot) and limiters.
You changed limp mode torque limiter !

by **vwphun** » Wed Dec 09, 2015 11:00 pm

capske wrote:After the chiptuning i started the car without problems. But i did get an injector coding error.
I have the renault can clip software. Original renault software. This software told me that i had an injector coding error, but the codes were still written in the car and i had only to erase the dtc.
Iff you don't have software to erase the error codes; after the tuning, press the both buttons with which you can go check milage etc. At the same time for about 30 seconds. This will erase the error on the display that tells you that the car needs maintenance.
Don't forget after the tuning, at the cars initial start up to switch the button for cruise control a couple of times over (at least 3 times), because else the cruise control won't work. You'll ten have to go to renault dealer or someone who has the can clip to reactivate it.

I hope you can apply this and that your tuning goes well.

How to reactivate cruise control with Clip, please? Thank you

by **capske** » Fri Feb 12, 2016 9:26 pm

To re-activate the cruise you can flip the cruise controle button over a couple of times when you start-up the car the first time after writing the file.

So in fact activate and de-activate the cruise with the button a couple of times, this should make do the trick.
If it didn't help or you forgot to do the procedure you can activate the cruise with the can clip.

I'll make a movie, post it on youtube and set the link.