noxePD130 wrote:Hi everyone,
I'm back with an update on my previous 65 mg tune.
I've been working on a new 70 mg map for my ASZ, now equipped with a GT1749VB turbo from the ARL, a Darkside upgraded SMIC (side-mount intercooler), and ARL N75 control maps.
I've recalibrated the Duration and SOI maps, and my calculated EOI is now around 10–10.5° ATDC at maximum injection.
I've also switched from MAF-based smoke limiting to MAP-based smoke limiting (MAF OFF).
However, I'm still struggling to understand how to properly calibrate the Smoke Limiter by MAP.
At the moment, the entire table is calculated for an AFR of 17, but I'm wondering if I should allow a richer AFR at low RPM to help spool the GT1749VB, while keeping AFR 17 once the turbo is producing enough boost.
Would anyone be willing to review my new 70 mg file and give me some feedback on the overall calibration, especially the Smoke Limiter by MAP, Duration, SOI/EOI and boost control?
Thanks again for your help!
https://mega.nz/file/dUYj1RIC#BXM49665ycsyRRYvGz8UUZA3F8aR6NFqDv130zwQKbE
You should allow a little bit more on boost limit map. Maybe 40-50mbar more than in boost request in case of some overboost. Same with SVBL: 40-50mbar more than highest value in boost limit map. Duration looks ok,SOI also looks ok. Ofc you can play with that later. On Torque limiter allow a little bit more fuel from 1500rpm and check how the car feels and whats going on with boost. Can always try allow more fuel in lower rpms to help spool up,but don't overdo it. If it's too much engine will choke and lose power. To fine tune N75 map: disable PIDs,fine tune N75 map,again emable PIDs and adjust those to your N75 map. Basically many small changes,tests,logs and that's it. Overall looks good. At least better than most of people's % tuning.