My name is ben I am very new to the mapping worl and still learning. I can flash pre done files but thats no fun really so I am now exploring the world of reading map files and using WinOLS. I have Pulled the stage 1 map file off my girlfriends 2012 kia rio 1.4 crdi with a Delphi DCM3.7AP ecu and I have been looking through it on WinOLS but it doesn't seem to make any sense compared to the previous VAG ecus I have looked at WinOLS gives over 8900 potential maps none of which I can safely see as "smoke map" or "hard cut" etc... so if anyone has A damos/A2L for this that would be helpful or if they could look through my bin file and possibly find the maps I am looking for and send me screenshots so I can source them that would be great too! I want to potentially create a map that I can do a Popcorn/Hardcut Limiter: I want a clean, aggressive hardcut rev limiter configured on the stationary/neutral RPM limiters, set to [5600 RPM]. I would like a clean zero-fuel drop-off so it bounces sharply. VGT Electronic Whistle / 'Owl Coo': I want the VGT/Pre-control duty cycle maps modified in the deceleration zones (zero-fuel columns at mid-to-high RPM) to close the vanes and create the 'owl coo' sound when lifting off the throttle. Smoke Switch / Rich Acceleration: I want the smoke maps/lambda limiters adjusted under high-load, full-throttle conditions to allow for heavy black smoke ('rolling coal') under harsh acceleration. Not really asking for much but finding the maps to create this desired remap for my girlfriend seems like it's impossible when I look through the map on WinOLS 2d view or text at 16 bit and dicimal. Is anyone willing to help me out? I can upload the bin file