Hello,
Is anyone here in the forum who will like to share some damos or mappack in which the DPF locations are included :)
I need them to manage to turn DPF off of my Mazda 5 , I'm also attaching the pictures of the dtc which i have :)



Thanks in advance

delete fault code reset dpf sensor ... upload the file

selveti7 wrote:delete fault code reset dpf sensor ... upload the file

Thank you mate for your spend timing for making dpf off from my file. but seems like this was made with software (I have the same solution :wave: ) :)
i was looking for damos for it to make good manual solution. Did you also test this soluition or not :shifty:

1. Clear dtc
2. Reset dpf
3. Remove dpf sensor temp
4. Write file to ecu

Manual solution with only dtc

P0549 - Exhaust Gas Temperature (EGT) Sensor Circuit
P2033 - Exhaust Gas Temperature EGT Sensor Circuit High Bank 1 Sensor 2
P2455 - Diesel Particulate Filter Pressure Sensor A Circuit High
P2454 - Diesel Particulate Filter Pressure Sensor "A" Circuit Low
P0030 - Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit
P2456 - Diesel Particulate Filter Pressure Sensor A
P2002 - Diesel Particulate Filter Efficiency Below
P2453 - Diesel Particulate Filter Pressure Sensor A Circuit Range/Performance
P2452 - Diesel Particulate Filter Pressure Sensor A Circuit
P2458 - Diesel particulate filter regeneration duration
P242F - Diesel Particulate Filter Restriction - Ash Accumulation
P2459 - Diesel Particulate Filter Regeneration Frequency

Free only for you. Test and report :D

Hello REALTEK,

I need some help in form of directions from you if you will sir :)

I've found the locations of the 3 dtc tables so I know how to delete DTC. I am struggling almost 2 years how to disable DPF with the proper DTC only so I really appreciate this reply of yours.

Questions are these:

When I read the file I did not have any DTC errors and I have reset the DPF. I will delete these DTC that you've mentioned. BUT, which sensor do I have to remove ? Psychically remove the harness or remove it with tuning (make it all the way 700c) ? Also, please tell me which sensor is which (in the dump): there are 3 sensors in a row that measure temp: one before cat, one before DPF and one after DPF. Which one is which if I count from left to right in the DUMP ?

Also which DTC do I have to delete for an EGR off ? My EGR is faulty though.

I have made a mappack with other than "usual tuning maps" like the intake throttle valve position on idle etc...

Also I do not know which one is the "start map".

And for me a very important one: I want to find a temp related map to EGR, like if outside temp is 5 and bellow EGR is not active. I want to find this map in order to disable the EGR with it so ECU can run the engine in "without EGR mode", every map to be adjusted to without EGR mode.

Sorry for my many questions but I want to learn for myself and my car which I own 6 years. I do not want just a "free" tuning from you.

Attached is my DUMP, if you need "my homemade" mappack please tell me I will send it to you!

Thank you in advance sir!!!!