Hi there.
For some time I've been facing a rather frustrating situation. Whatever I do I can't get rid of this correction/s. Recently I refurbished the injectors ( 0445110297 ) and then tested on EPS 708 Bosch bench. They all are in perfect condition and got new IMA codes being complied with Bosch standards. I also installed another set ( 0445110259 ) with 0.xx my/imp corrections from a different car and nothing changed, on mine remained the same. Last year I switched the codes randomly between the cylinders and the 6.01 correction switched from 3rd cylinder to 2nd and this how remained. This was very annoying because this eliminates a compression issue. Also as far as I understand the corrections are not related with compression on this engine as there are no sensors inside that could monitor each individual cylinder pressure. The ecu can measure revs but not measuring force on each individual cylinder. However for the peace of my mind next week I'll perform a compression test. Tomorrow I'll install mine injectors back but I doubt anything will change.

PS. The car is stage 3.

Any information or advice is welcome.