Bravo jtd 105 (EDC15C5)

Help and tips about your tune, post your work in here.

Return to Rate My Tune

Bravo jtd 105 (EDC15C5)

Postby Russo_n » Tue Feb 17, 2015 8:59 pm

Hi everyone i have just began to change my map and i have some doubts.

1- How do i calculate end of injection (EOI)??? I have SOI in degree BTDC and duration in microseconds, how do i know when will the injection end???

2-In this ecu driver wish is in mg ou mm3? (Does it use mm3 in all maps? or it uses mm3 in some and mg in other???)

3-How shoud i aprouch rail pressure pre control map?? The higher the value the more the valve closes?? or is it the other way around??

4- How do calculate the IQ based in injection duration, rail pressure and SOI, so that i know how much the engine can inject and burn??


I just raised Rail pressure a litlle bit and the torque limiter, because it is much lower than in drivers wish, but i would like to know how to calculate this values so i am not asking thinhs that it cannot do.


Best regards

Nuno Russo
You do not have permissions to view the files yet. You have to be registered and you have to make at least 3 quality / unique posts.

Russo_n
New user
 
Posts: 12
Joined: Mon Oct 07, 2013 10:58 pm
Location: Portugal

Re: Bravo jtd 105 (EDC15C5)

Postby Russo_n » Wed Feb 18, 2015 8:09 pm

Hi

I already know the answers to my questions, thanks anyway.

Russo_n
New user
 
Posts: 12
Joined: Mon Oct 07, 2013 10:58 pm
Location: Portugal

Re: Bravo jtd 105 (EDC15C5)

Postby Russo_n » Wed Feb 18, 2015 9:28 pm

I just finished my first tune can anyone take a look to see if i am on the right way?

Thanks
You do not have permissions to view the files yet. You have to be registered and you have to make at least 3 quality / unique posts.

Russo_n
New user
 
Posts: 12
Joined: Mon Oct 07, 2013 10:58 pm
Location: Portugal


Return to Rate My Tune

Who is online

Users browsing this forum: No registered users and 1 guest