Dear,

i use EcuSafe 2.0 and DPF is off, but i have problem with engine.

http://www.youtube.com/watch?v=by8ctk55bik

i want try WinOLS and...

all 8bit adress switch 0?
6112E
61134
61137
61138
6113A
61145
61151
62A54

thank you

i have Peugeot 607 2.2 hdi 2002 with EDC15C2

your access to diagnosis PP2000?? 406 for one what I was doing exactly the same thing done. was chewing the cable leading to the high pressure sensor pad. it is best to first check the car through PP2000. then write what it has errors.

tomik1987 wrote:your access to diagnosis PP2000?? 406 for one what I was doing exactly the same thing done. was chewing the cable leading to the high pressure sensor pad. it is best to first check the car through PP2000. then write what it has errors.

Ahoj Tome,

I have PP2000 - to diagnose me spell failure on the temperature sensor before the executioner. But I showed this to remove FAPu using ECUsafe. So I do not attach much weight - and after clearing the error I now PP2000 display anything and everything is ok.

Auto run on foot gas well, I changed the DRV valve, balance air, low pressure pump, head gasket, but the variation in speed is still low. I wonder if you can not do either high pressure sensor on the rail or shut-off valve on the high pressure pump.

Anyway, thanks for any advice.

Thanks Tom

a na originálnej mape keď si ju tam mal otačky ti tiež skákali? mne toto spravilo na 807 že mi začali blbnúť otáčky keď som upravil súbor v ecu safe navyše ja tam mám problém lebo sa mi nedajú mazať chyby na tejto 807. jednoducho vypíše závada komunikace.
včera som súbor upravil cez winols postupoval som ako pri C5. auto ide. ale vyhodilo strašne veľa chýb s aditivovaním. chyby sa nedajú mazať.

in english:

and the original map if it there was also a speed jumping? About this made ​​the 807 that I started fooling around turns when I edited the file ecu safe in addition there I've got a problem because I can not erase the mistakes of 807 simply prints the error communication.
Yesterday I set themselves through WinOLS as I progressed at C5. car goes. but blew an awful lot of mistakes with doped. Error can not delete.

I have some problem with old map. I have fault code P1421 with new map. When I use old map, i have more fault code about addition.

P1421 is a exhaust heat sensor - its a lambda sensor?

Hello m8, you have solution to this problem , I have similar problem with Peugeot 607 2.2. HDI , ECU- EDC15