Hi need to remove dpf/fap from my peugeot 407 1.6 hdi bosch edc16c34 hwid 1037380721
Can somebody use winols, i was told the ecusafe and volta is not good :(
Attach full bdm read from my ecu
Thanks

I was use this manual switch :

To disable FAP on edc16c34 we need only 2 bytes.
So we must find this string and set 00 00 in it:
00 7F 00 00 00 00 00 00 00 00 00 00 01 00 0C 3B

for now everything is OK, just show me fault fuel cap something which is normal :)
Hope is stay like it is :)

Regards

hello,
your mod here

Hi mate i was have removed before DPF and EGR because my car goes to limp mode all the time i decide to remove only DPF.
But i was tested on my mod 2 byte switch off and is exactly same :( turbo was repleaced 3 months ago is fine till now but when my car goes to limp mode is error in ecu "turbo charger over bust condition" :(

What i can due if i remove the error code from ecu my car will go to limp mode or not ?

Thanks for your reply

Well you need to fix turbo problem or turbo control problem, if turbo was replaced its probably turbo control, check vaccum hoses , turbo actuator, and turbo actuator control valve

Thanks mate for your reply, i will check but i have another software for my ecu which i pay for this.
This is a full remap increase power etc. wit this software everything is ok, no errors in ecu but i dont want this remap is too much for 1.6hdi :/

blackangel wrote:I was use this manual switch :

To disable FAP on edc16c34 we need only 2 bytes.
So we must find this string and set 00 00 in it:
00 7F 00 00 00 00 00 00 00 00 00 00 01 00 0C 3B

for now everything is OK, just show me fault fuel cap something which is normal :)
Hope is stay like it is :)

Regards

Software which you use to manually shutdown FAP?

hex editor :)