Hi,
i need some help because i have a Peugeot sw 307 hdi 2.0 110 hp year 2003. My ecu is a Bosch EDC15 C2/0281011081 RHS, my problem was a bad repro because file was damaged and ecu got bricked so i took it to the bench and opened it up to enter in boot mode with galetto 2 read and write, put it in the car programed the key and bam!!! it worked but thumbs down :thumbdown: because car stalls at 2500 rpm and on road it stalls all the time so i did a check up with diagnostic machine and boost pressure sensor,accelerator pedal sensor and common rail pressure comes up, so i changed all sensors and still the same problem. I then bought a used ecu but i need to virginize it but don`t know how, could someone tell me what tools i need to buy to do this and can someone send me virginized file for this ecu.

Best Regards
Nesport

just resolder small chip 95p08 on the back side of the ecu bord 2x4 pin chip...that is eeprom.
your old ecu is probably burned - power supply line to the sensors is burned.

Thank you very much for your quick reply, you saved me alot of time googling. :D

Best Regards
Nesport :wave:

no problem, it will be 5min job and car will run normaly :)