Hi all,

I recently bought an R32 and was interested in checking if it's standard ECU mapping and not already tuned. I bought it via Evans Halshaw and it's got a few tuning parts fitted (brakes and engine mounts that I've spotted so far) so I'm worried it's been tuned (possibly badly)


I have an old original KWP2000 and a clone Galletto, can either of these just do an OBD read in the car?

I have a feeling the Galletto might but I'd need to bench read it and put it in boot mode.

Is there anything I can buy to do a read and/or checksum check to check the car is at least standard, even if I don't want to tune later?



Thanks for any advice


In the mean time I'll do lots of ME7.1.1 reading!

Dave

if it supports med9 ecu then you can read.

bud if its have noread protection you need bootmode or BDM