iveco 3.0 edc17cp52 problem

by **andreqn** » Fri Oct 09, 2015 7:44 am

Hi to all mates ,
i have my firs edc17 and make a stupid mistake to read the car with galleto - boot mode and the file was 2MB , and the bigest folly is to use ecu safe and write back .The car is Iveco Daily 3.0 2013 - EDC17cp52
Is thear a way to recover the ecu and file ? if i write ori file from another same ecu , the immo will be a problem , i can bay second hand ecu but the problem will be the same .
I`ll be extreamly thankful for any help

by **Dmitry** » Fri Oct 09, 2015 1:10 pm

In the boot mode
Write back the original.

by **spychu14** » Fri Oct 09, 2015 2:57 pm

First make a read by bootmode and attach here bootmode read and OBD2 read.

by **andreqn** » Sun Oct 11, 2015 9:48 pm

I read bdm but my galletto is clone and read only 2 mb . I write back the read file but no succses? So if i by a good tool is the file allready damage.? And i know that these ecus have TP and one read and write locke them ? Is there a solution or i must buy new ecu?

by **mahmod_q** » Tue Oct 13, 2015 2:34 pm

thanks for all

im new can any one help with software to remove dpf

by **andreqn** » Tue Oct 13, 2015 7:32 pm

here is what i read via galleto and ktag

by **Dmitry** » Wed Oct 14, 2015 9:05 pm

I think 1752 should have 4 MB
It must be programmed using ktag
eeprom different - it's bad.
But all the same, program ktag, then write here about the results
reading nothing could collapse

by **andreqn** » Fri Oct 16, 2015 6:49 am

Dmitry wrote:I think 1752 should have 4 MB
It must be programmed using ktag
eeprom different - it's bad.
But all the same, program ktag, then write here about the results
reading nothing could collapse

I don`t understand what do you mean . What to program with ktag ? i haven`t a good file to write it ...