hello new to forum I have learnt a lot from reading peoples posts
so far I have
the orginal ecu dump from the pcm of car using elmconfiq
I have used ecu safe 2 to remove the dpf said this is removed
then loaded file back into ecm titanium to re add correct drivers as ecu same just used a generic siemens ford driver
im now a little stuck as was planning to reflash with elmconfiq but says the fireware are different from orginal and tried orginal untouched and says same
im trying to get fg tech software I have it but can not get it to run as it should , whats best software to use to reflash to this car and any general help on what I have done also I also have kpw 2000 + kit and software would that be any good , thank you
martin