Hi everybody,

I open this thread for my project on my peugeot 307 hdi 2.0 110hp. This is an EDC15c2 ECU.

First my goal is to do a quick optimisation, 80mm3, 2200mbar turbo boost mainly. And in a second time, optimise this mod to burn a mix of vegetable oil and diesel (50-50). I Know I have to set about 3° more advance in SOI, and maybe more parameters...

But first I have some trouble to indentify some maps. I think my map pack is 80% done but I still have some doubts.

First this one :
is it a torque limiter ? or a IQ limit by gear engaged ?


this one looks like a torque limier too :


I this I'm good with this one but I need confirmation :


And for me this one is SOI for preinjection. Am I right ?


And the last one can you confirm that is a correction pressure by temperature ? Do I need to modify values in this one to have 1.2 bar of boost ? (2200 mbar absolute)


Thanks in Advance for help, and sorry for my english which is far from good...

Bye

and here is my map pack

Just a little kick the rigth way here.
The key word is limiters.
674BA
674E6
68846
68D7A
68DBA
68DFA
68E34
68F84
774BA
774E6
78846
78D7A
78DBA
78E34
78F84

There migth be more, this was wath i found so far.

Cheers

thanks for your help !
There is some limiters where IQ far below the main 19x1 map (torque map), or at 0 mm3 above 2500rpm on another limit map.
Is it possible that theses kid of maps are for degraded mode ?

Like 674BA , 674E6 and so on ?
Mabye this can be Torque limiter for fuel (limp).

Yes that's what I think, it might be for limp mode.

but this one at 63E62 It seems to be a torque limiter but I'm not sure...

Try user (Nemo_K30) P307_ori_mappack_ver2.rar.I have tasted my own car peugeot 307 2.0 hdi 79kw 2003 bosch fuel injector (9641742880) is working good.But ecu file software version is a bit older (1037 36 4193) but working 100%.If you need any ecu immo off or ecu schematic diagram write me i will give for free (my english bad sorry).
https://www.ecuedit.com/post45224?hilit=edc15c2#p45224
.

Hi my maplist attached full ;)
Used for my own car at least 5 years long contiually develop.

Small hint with proper Turbo Map and N75 tune you can use 1.3 Bar boost pressure with 1.35 bar overboost
and 84 mm3 for 365 Nm and 75,35 mm3 for 142HP

user202 wrote:Hi my maplist attached full ;)
Used for my own car at least 5 years long contiually develop.

Small hint with proper Turbo Map and N75 tune you can use 1.3 Bar boost pressure with 1.35 bar overboost
and 84 mm3 for 365 Nm and 75,35 mm3 for 142HP

Hello, do you have a version of the map KP (Ols map pack) file? Thanks!

Can anyone say, where are the SOI limiters(not SOI maps) in this file?
It`s the same ECU, but car is Citroen