Bosch 16u34 passat

by **Simanic** » Tue Jun 11, 2013 12:18 am

Is enyone read/write dump form ecu with mpps v12, does it work correctly?

Passat 3c 2008, 77kw
ECU: Bosch 16u34

Tnx in advance!

by **serguei** » Tue Jun 11, 2013 8:35 pm

Yes, it works correctly.

by **autoelectro** » Wed Jun 12, 2013 5:50 pm

Hi,
I tried it with v13 and it's work fine!

by **Simanic** » Wed Jun 12, 2013 8:48 pm

Thx on answer!

by **morfej** » Thu Aug 01, 2013 12:21 pm

V13 is just chinese makup of V12 :)

Yes V12 works just fine.

by **tsj** » Thu Aug 01, 2013 2:57 pm

It works fine on this ECU but there are a number of ECU's which are not really safe with the MPPS china clone.

Get yourself a european Galletto V54... works a treat ;)

by **mocPL** » Mon Aug 12, 2013 12:13 pm

My story is: Just few days ago I tried to remove a DPF on Golf 5 BXE engine using MPPS 5.0.1.10 and crashed the 2MB flash content. Don`t know whats happened, maybe because of that chinese clone or too low voltage, but nevermind, then trying to do the recovery with the file readed earlier, it showed up an error, didn`t knew what kind of issue was the mentioned error till I connected the galletto interface that describes literally ALL problems and faults during write and read operation. My point is to say that the MPPS doesn`t describe transmission faults, just pops up a mail window to contact MPPS staff. In my opinion galletto has a better monitoring possibilities to identify such problems, than the MPPS.
Any observations?

by **mocPL** » Mon Aug 12, 2013 1:09 pm

mocPL wrote:My story is: Just few days ago I tried to remove a DPF on Golf 5 BXE engine using MPPS 5.0.1.10 and crashed the 2MB flash content. Don`t know whats happened, maybe because of that chinese clone or too low voltage, but nevermind, then trying to do the recovery with the file readed earlier, it showed up an error, didn`t knew what kind of issue was the mentioned error till I connected the galletto interface that describes literally ALL problems and faults during write and read operation. My point is to say that the MPPS doesn`t describe transmission faults, just pops up a mail window to contact MPPS staff. In my opinion galletto has a better monitoring possibilities to identify such problems, than the MPPS.
Any observations?

AAAAAHHHH almost forgot, the problem was "speed change error"
I solved it flashing that M58BW16 again with BDM.