Audi q7 3.0 TDI DPF removal

by **grabkid** » Fri Dec 05, 2014 2:12 pm

I woul'd like to remove my dpf on the q7 because i have the light on, and its in LIMP mode as well.
Any advice on what softwares and cables should i use?
I have autocom cable and vag-com cable.
Thank you in advance :).

by **avtodiagnostic** » Fri Dec 05, 2014 6:54 pm

First check wath dtc error you have, or try make regeneration , i dont understand why when the light is on , people will remove the dpf, try first resolve ,if that not help, than remove it :thumbdown: ;)

by **grabkid** » Sat Dec 06, 2014 2:35 am

I tryed the forced regeneration method, i even took the dpf off and cleaned it with jet of watter, but after a week or two the error reappears.

by **kpematop** » Tue Dec 23, 2014 7:13 pm

post the ori

by **audi a4 b7** » Tue Dec 23, 2014 9:15 pm

Post ori dump

by **grabkid** » Thu Dec 25, 2014 1:01 pm

I took off the dpf , and drilled two holles aprox 20mm eatch, so far so good, after two weeks and 1000 km, there was no problem.
If the error reapears i might consider turning off the dpf with ecu remap.

Thanks for the support, i will upload orig dump asap.