I have an Audi a3 8p FSI 2.0 , it has an Bosch Med 9.5.10 ECU.
I was writing a modified file using ODB2 with Galleto 1260 and computers hangs, so the ecu is bricked, car does not start.
Before that, I did a backup of the ecu (File size is 2 MB), I'm aware that put the ecu in boot mode shoud work, but I'dont know which pin shoud I ground.
I have seen many examples talking about pin 24, but this does not work on my ecu.
My ecu has a M58BW016 flash chip, which pin is the correct one?
Users browsing this forum: No registered users and 0 guests