blood69 wrote:Hi, i was able to reverse engineer the BMWs Motronic 174 DME used on the E30 316i .
I just bought an already Tuned chip and compared with the original on the Car. Using TunerPro and a XDF file for the 173 DME (e30 325) i was able to change the memory addresses for each table, since the tables are the same size, and created a new XDF to the 174.
Now i'm trying to figure it out how to calculate the checksum and the correct memory address.
I think its the 1f20,1f21,1f22 and 1f25 memory addresses but not sure.
blood69 wrote:Shooting, i'm guessing you're the guy with the bathroom key.
Anyways, It would be nice that's mentioned on the email after registration.
blood69 wrote:Fair Enough.
But u have to consider that there's other forums out there and people rotate between them.
I'm not saying the introduction is a bad thing, but then again, you should consider asking for a introduction and sending the link on the register email.
When we make the 1st post we don't have a clue that is mandatory.
blood69 wrote:Like i believe it
Half of all your posts on this forum is this shit:
"Look here before asking for anything ----> introduce-yourself"
Users browsing this forum: No registered users and 0 guests