The car have 0.275 nozzles, 11mm plumber... The voltage is stock, last column changed to 65... TL 65, DW 66, SL 65, boost 2800mbarz, 1 degree advance. Can you plz chek if the map linearization (it have 3bar map) is ok and if you see any other mistakes in the file...
Thank you very much!

Nobody?

I got the power, but when i reach around 4000rpm the car stops ( when the engine is hot)... When the engine is cold the car goes to the end... Its something related with temperature, any ideas? The map sensor is atached to the intake manifold... I notice that the fuel temp is going a little over the 66 degrees...