trevor wrote:I've got exactly the same problems .
One switch solution works but car is coming back with errors related to the additive level.
Some examples coming back with level to high the other with level to low .
I can remove fault codes and everything is fine but smoke is another issue .
bursuc wrote:You use WinOls to do iy manually ? and if so , you need to remove dtc table about aditive aswell ? and you need to turn off DPF from BSI with pp2000 ??
Best regards
protuning wrote:Affirmative
I did a lot of cars with this solution
What is important is preserved DTC table
This is a graceful shutdown of FAP in this ECU. 100% works solution.
ECUSafe is a bad tool only earsin DTC-Table, bad for a car and not dpf off
VOLTA 1.3 do a single switch and dpf is off, but also excludes a lot of other unnecessary mistakes
Best Regards :D
Majes wrote:Hi everyone!
I can't obtain winols (yeah 1000$), so i have a hex editor which I can see the dpf off phrases:
00 9F 00 00 00 00 00 01 01 00 0C 3B
And as i have learnt here i can see that i have to change it to :
00 9F 00 00 00 00 00 00 01 00 0C 3B
BUT! this string is inside the bin file TWO TIMES! do I have to modify the byte both times or only one? if so, which one of them?
Return to FAP / DPF Filter Removing
Users browsing this forum: No registered users and 2 guests